Enigmatic
Bug
EXPERIMENTAL · may have bugs
Desktop Use
Under Development
Under Development
Uno Breadboard Simulator
Write a sketch, build the circuit on the breadboard, wire it to the Uno or the power supply, and press Run. Everything runs in your browser on a desktop or laptop.
Choose a component, then tap two holes. Press and hold a button to push it.
Uno: No sketch uploaded
sketch.ino
changed since Upload
Serial Plotter
What this simulator does (and does not do)
- Made for a desktop or laptop screen, with a mouse or trackpad.
- Runs a subset of Arduino C: setup() and loop(), int, long, byte, bool, float, arrays, if, for, while, switch, and your own functions.
- Built in: pinMode, digitalWrite, digitalRead, analogWrite, analogRead, delay, millis, micros, map, constrain, tone, noTone, and Serial.print, println, and write.
- Build checks the code, Upload runs the compiler checks and loads the sketch onto the Uno, and Run does Build, Upload, and Run in one step. Build and Upload stop a running sketch first.
- Components: resistor, LED, push button, wire, knob (potentiometer), light sensor (photoresistor), piezo buzzer (Sound starts off), and RGB LED. Drag a knob or a light sensor to change it.
- Power supply: 3.3 V, 5 V, or 9 V on Bus A (top rails) or Bus B (bottom rails), one post per bus. Its GND is separate from the Uno GND: wire the bus − rail to an Uno GND pin so the sketch and the supply share a common ground.
- Mistakes burn parts, marked with a red X: an LED over 50 mA, a resistor over 0.3 W, an Uno pin over 80 mA or above 5.5 V, and the Uno itself above 5.6 V on its 5V pin. Reset Breadboard replaces them and keeps the wiring.
- Examples menu with sub menus, as in the Arduino IDE: 35 examples, including the Numerics lessons in C (Carpenter Software, Numerics), TrafficLightFSM (a finite state machine in loop()), TwoBotsFSM (two robots, two state machines with Enter, Execute, and Exit that send each other messages), and TimerButton (Timer.h and Button.h in C).
- Multimeter (top of the left column): V reads from the red probe to the black probe (click a probe, then a hole or pin; a PWM pin reads its average); mA and Ω read the part you click. Ω reads only with the USB unplugged and the power supply off.
- Serial Plotter: always shown beside the code, it graphs the numbers the sketch prints, one trace per number on a line; "name:value" names a trace, as in the Arduino IDE 2.
- Tap the USB jack to plug or unplug the Uno. Hold the red reset button, or wire RESET to GND, to hold the Uno in reset.
- Your sketch and circuit are kept in this browser only (see the Privacy Policy). Save downloads an .ino file; Open loads one. Nothing is sent to a server.
- Registers DDRB, PORTB, PINB, DDRC, PORTC, PINC, DDRD, PORTD, and PIND work, so bare metal code such as DDRB |= (1 << DDB5); runs.
- The LED current follows Ohm's law: I = (V − VLED) / R. The page warns above 20 mA per LED or pin.
- Not covered: libraries, #include files, String, interrupts, timers, and exact timing. An int is 16 bits on the Uno; values wrap when stored.
Designed: Jesse Carpenter and Claude (Anthropic)
Simulator code: MIT License.
Arduino and Uno are trademarks of Arduino SA. This simulator is not affiliated with or endorsed by Arduino.